FlightScnr Firmware Installer

Installer powered by esptool-js 0.5.7.

Auto probes the connected chip after Connect (FlightScnr board marker, then flash manufacturer). Confirm before Install — USB IDs alone cannot tell the boards apart.

Erase entire flash?

This will permanently erase all 16 MB of flash memory on the ESP32. Firmware, Wi‑Fi credentials, saved settings, and route cache will be deleted.

The board will not run FlightScnr until you flash firmware again.

Loading latest release…

Not connected

Before you start

  1. Use Chrome on a desktop computer or laptop.
  2. Connect either the LILYGO T-Encoder Pro or the Waveshare Knob Touch LCD 1.8.
  3. T-Encoder: if the USB port does not appear, push the screen down (BOOT) and hold, tap RESET, then click Connect.
  4. Waveshare: the USB-C plug orientation decides whether the ESP32-S3 or the secondary ESP32 is connected. If Connect reports a plain ESP32, unplug, flip the cable 180°, and Connect again.
  5. Leave Board on Auto, or pick manually. USB IDs alone cannot tell the boards apart; after Connect, Auto looks for a FlightScnr board marker in flash, then suggests a board from the SPI flash manufacturer. Always confirm before Install — flashing the wrong binary can succeed but leaves the display and controls dead until reflashed correctly.

Choose Full install for a first-time install, after Erase flash, or when replacing factory firmware (flashes at 0x0; clears Wi‑Fi and saved settings). Update app only flashes the application at 0x10000 and 0x650000 (both OTA slots; needed after an on-device OTA) and keeps settings when bootloader and partitions already match.

Log


      


      

        FlightScnr by Yash Mulgaonkar
        ·
        Releases